Introduced the possibility to visualize a drawing of the bolted joint together with the calculated compression cone, by right-clicking on a bolt group and selecting View joint drawing. This helps to double-check the setup before the analysis and more easily spot possible mistakes in the inputs.
Corrected the calculation of the compression cone when the counterpart is a plate with threaded insert (with or without helicoil) and is narrow enough to be considered as a nut, to consider the possible presence of a washer with external diameter bigger than that of the bolt head.
Corrected the calculation of the compression cone parameters such that if a partially developed cone is obtained but the cone does not actually sit outside any of the plates, then it is switched to a fully developed cone. Due to this change the compression cone half angle is sometimes calculated based on the plate with the maximum diameter.
Other minor corrections to the calculation of the compression cone.
Corrected the calculation of the plates’ compliance to consider the bottom plate in all situations. Previously the bottom plate was not considered in certain situations.
Corrected a bug whereby if Both was selected for washer setup and then the counterpart type was changed from nut to threaded insert, the washer setup selection was adjusted in the MARS window without also updating the analysis data.
